Extruder
- This topic has 2 replies, 2 voices, and was last updated 1 year ago by .
Hi, i’m planning to build/buy an extruder. What electronic components etc is “must buy” and which can i make on my own? I live on a farm so we have a lot of equipment and materials. Want the cheapest possible.
Kind regards Mathias
2 replies
0 subscribers
0 saved
0
likes
sort on most likes
The heater bands and controller/SSR/TC part of the system is probably a must buy, though you may have some heater equivalents. They are relatively cheap.
If you have a way to provide a low speed/high torque drive with your current equipment that is safe to operate, you may be able to save that part. If you search the forum, there are a lot of discussions on speed/torque/couplings.
Viewing 2 replies - 1 through 2 (of 2 total)
You must be logged in to reply to this topic.