- This topic has 3 replies, 2 voices, and was last updated 5 years ago by .
Can anyone guide me in order to select the right hexagonal bar?
I do not seem to find it anywhere in Australia.
I’m not from Aus, so I cant promise this is correct, But for me, I’ve found a crowbar handle (trimmed off at one end to length) works perfectly. Obviously, Its got to be a hexagonal crowbar, but all mine are, so that wasnt an issue.
I used the largest one my local hardware shop stocked. But then, I was quite happy to adjust the laser files to fit my needs. I ended up with a bar with a 1 inch “diameter”
The best advice I can offer would be to get your hex bar before you send any metal to be cut, that way you can adjust the cuts to suit
You must be logged in to reply to this topic.