We've just launched our map. Add yourself by clicking here!

close

Mass Production Molding with Extrusion

This topic contains 0 replies, has 1 voice, and was last updated by  Butte Metz 8 months ago.

1
Butte Metz btmetz

Mass Production Molding with Extrusion

08/08/2020 at 03:08

 

Full description in the comments.

 

Basically I extrude into a heated pot, then transfer the blob of hot plastic to the air powered compression molder.

 

Mold is liquid cooled.

 

average 2 min per part.  1.5 min to cool, 30 seconds to remove.

 

 

0 replies
1 subscribers
0 saved
1 likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of yash gohel
    Profile picture of Văn Phòng Phẩm An Lộc Việt
    Profile picture of Maxim Yahia
    Profile picture of arif rahman saleh
    Profile picture of PON MAA KISHAN A
    Profile picture of Akshay Ramesh
    Profile picture of Anik Islam
    Profile picture of Ananyabrata
    Profile picture of Aditya Lavania
    Profile picture of Rocky C
    Profile picture of Alberto Bauer
    Profile picture of ha
    Profile picture of Francisco Ubilla Garcés
    Profile picture of Ridho Gunawan
    Profile picture of Lautaro
    Profile picture of LEHYAN YOUSSEF
    Profile picture of achal patel
    Profile picture of Debananda Mishra
  • Recent Replies

  • Support our projects on Patreon so we can keep developing 💪