We've just launched our map. Add yourself by clicking here!

close

Topic Tag: motor

Viewing 30 topics - 1 through 30 (of 109 total)
Good afternoon, I'm currently in the process of trying to finish up my shredder so that I can actually start shredding plastics! I've come across a final issue ( I hope ). Currently I have the shredder assembled, and I also have two keyed motors (7/8 inch shaft) and a Boston gearbox which reduces to about 60-70rpm with a keyed shaft ~1 1/4 inch diameter and a gear with almost 1/2 inch teeth. Currently the shredder shaft I have is not keyed, and seems to be about 20mm, almost 3/4 inch diameter. I'm trying to figure out the best way to connect the motor to the shredder, I was thinking of adding a gear on the shaft and using a chain, but I can't seem to find the correct sprockets and shaft connections required. Or would it be cheaper to key the shaft and use a keyed connection with sprocket? Any assistance would be greatly appreciated. Thanks, David
Viewing 30 topics - 1 through 30 (of 109 total)
Support our projects on Patreon so we can keep developing 💪