We've just launched our map. Add yourself by clicking here!

close

ADVICES ABOUT COMPRESSION MOLD

Christian Henriod chenkus

ADVICES ABOUT COMPRESSION MOLD

28/07/2020 at 18:30

Hello! Hope everybody is doing well.

 

I want to compress the planter which is in the attached drawings. Before quarantine, I got a big pizza oven and the idea is the build an external press machine, put the plastic flakes in the mold, melt them and then press it on the compression machine.

 

I need some advice about mold building:

– Which should be the thickness of the metal sheets to use?
– Should the mold need to be structured?
– Do the parts need to be CNC cut?
– and any further detail that could help me to make a good mold.

 

Thanks in advance!

Attachments:
2 replies
1 subscribers
0 saved
0 likes
sort on date
starter
25/06/2021 at 23:11

I’m developing a piramid Shape Flower pot mold using 4mm thickness steel mold. I’m only a beginner and would like your guide and feedback if it requires some modifications. I have attached the pictures to view the mold. Do you think my MOLD is feasible?
Thanks,

Attachments:
helper
07/08/2020 at 15:59

– Which should be the thickness of the metal sheets to use? 3 mm or 4 mm
– Should the mold need to be structured? what do yo mind?
– Do the parts need to be CNC cut? yes is better but most expensive 
– and any further detail that could help me to make a good mold.
what  are the units in te drawing?
You have to decide the thinknes of the product and how much plastic are you going to use
Its too importan the  release angle for the compression depends of the mould 10 to 20 °
the distance of the mould with the flake(before heating) the botton and the top enter to the oven
If you can make a lining of teflon to the mould  you are going to save a lot of headaches

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪