We've just launched our map. Add yourself by clicking here!

close

Aerated plastic – insulation?

Tagged: 

Sean Cunningham skinlessfrank

Aerated plastic – insulation?

22/04/2016 at 21:29

Has anyone experimented with injecting air into plastic to create an insulating material? I was looking at PolyISO & Polystyrene insulating boards and wondered if there was a method for smallscale production. There is a lot of documentation about preventing air pockets, but I have not seen anything about adding “microbubbles” in a uniform way…

I came across air injected concrete when looking at lightweight concrete options for my projects and thought there might be parallels in the process. I have not had time/equipment to experiment bout thought I throw it out there for consideration.

Cheers,
Sean

3 replies
0 subscribers
0 saved
0 likes
sort on most likes
warrior
24/04/2016 at 08:54

never tried that. But it is a quite a common technique in the industry, never seen it on a small scale though..

helper
25/04/2016 at 06:40

You would need to get the kPa/psi air pressure absolutely correct for each application, apparatus. Compressed air can be dangerous if not used correctly, so I would do lots of research then talk to a expert in compressed air/engineering

starter
11/05/2016 at 04:45

A couple of things to watch out for with air. First, you have to keep it in the melt. Without a professional screw, there’s very little preventing your air from just flowing upstream and bleeding out of your feedthroat. Second, the tiny bubbles are going to want to combine into larger bubbles, which will just show up as popped blisters on the surface of your plastic instead of a foam.

In industry they use expensive “blowing agents” which react chemically when they reach a certain temperature, releasing the gas after the chemical has been evenly distributed in the melted plastic to prevent the bubbles from coalescing into larger bubbles.

Not to completely shoot you down, you might consider water as a blowing agent. You could get some porosity using moisture. Good luck if you try it!

Viewing 3 replies - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪