We've just launched our map. Add yourself by clicking here!

close

Barrel heating time

This topic contains 0 replies, has 1 voice, and was last updated by  Bashir Muzakkari 1 week ago.

0
Bashir Muzakkari muzakkar

Barrel heating time

09/09/2020 at 10:47

Dear all,
I followed the PP extruder design and was able to develop one, during the test run I noticed some issues with the heating time.
The temperature of the three heating zones are short of 40 degrees each, the feeding zone does not exceed 150 degrees while the barrel and the nozzle zones does not exceed 160 degrees respectively.
Please what could be the problem?

0 replies
0 subscribers
0 saved
likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of Bashir Muzakkari
    Profile picture of PlasticHub
    Profile picture of kiss anime
    Profile picture of Matías Leguizamón
    Profile picture of Tom
    Profile picture of CHRISTIAN HELBIG
    Profile picture of Sruthi
    Profile picture of Oscar
    Profile picture of Stan
    Profile picture of Simon Morrison
    Profile picture of Alexander
    Profile picture of Albert van Iperen
    Profile picture of Ansif T A
    Profile picture of Cezary
    Profile picture of Lucas
    Profile picture of Coral Ben-Aharon
    Profile picture of Sneyder
    Profile picture of John Carter
  • Recent Replies

  • Support our projects on Patreon so we can keep developing 💪