We've just launched our map. Add yourself by clicking here!

close

Compression Molded Duck Decoy Art

This topic contains 0 replies, has 1 voice, and was last updated by  Lindsey 5 months ago.

0
Lindsey distilledart

Compression Molded Duck Decoy Art

01/02/2019 at 05:25

Hi there. This is a lofty first project but I’m tackling casting a duck sculpture with the hopes of making floating sculptures for an outdoor art installation.

I’ve sculpted the duck and I’ve got a quote out for a 3D scanning that would produce an aluminum outer and inner mold so I can cast it somewhat hollow. I expect that it’ll be two separate parts to cast as well as installing a flat sheet base to seal the air to keep it buoyant.

I’ve got parts on order for the compression oven and have applied for several grants to fund this.

Cheers!
Lindsey

QUESTIONS – will the stainless shredder handle thick HDPE like buckets or pipes? It’s a good source of material but I’d rather not destroy my shredder.

Attachments:
0 replies
1 subscribers
0 saved
likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of Mikee
    Profile picture of Андрей
    Profile picture of Andrew Henderson
    Profile picture of Alexandros
    Profile picture of Tiger Bean
    Profile picture of Gaurav Bhosale
    Profile picture of Gao penglong
    Profile picture of Ruize
    Profile picture of Milson Marinho
    Profile picture of Nha Khoa Lovely
    Profile picture of Christophe LEJARRE
    Profile picture of adele foucart
    Profile picture of Nicolas
    Profile picture of Markson Joy
    Profile picture of amruta
    Profile picture of Xien Tv
    Profile picture of barbara
    Profile picture of George
  • Recent Replies