Cost and time for making 3D printer filament
- This topic has 1 reply, 2 voices, and was last updated 3 years ago by .
Hello,
I just wanted to know if someone here successfully implemented the process for converting old plastic to 3d printer filament.
If yes would really appreciate any nsight on following queries:
1) Approximate cost of production per kg or lbs for you
2) Approximate batch quantity you were able to achieve
3) how much time did a single batch it takes to process.
any insights would be highly appreciated.
Regards
Manak
To make filament you would need a device to “pull” the filament coming out of the extrudeur to get a precise diameter. This device does not seem to be in the scope of the next V4 PP. I am working on a device which will be relatively cheap to acheive this. I put a photo of my first proto, which needs to be improved, especially mecanically. When it’s fully working i will post a video, but this will not be before one or two months. Based on arduino and cheap stepper motors.
You must be logged in to reply to this topic.