We've just launched our map. Add yourself by clicking here!

close

Electronics and Wiring help

This topic contains 1 reply, has 2 voices, and was last updated by  Dave Hakkens 5 years ago.

1
Asher Holloman asherholloman

Electronics and Wiring help

14/07/2015 at 19:22

I am planning on building an injection molder, but I am needing help with the wiring setup. Wiring is not exactly my strong suit. How did you guys hook up the whole electronics system to power and can you share some photos of your wiring set ups?

1 replies
0 subscribers
0 saved
1 likes
sort on most likes
warrior
16/07/2015 at 15:27
0

Hi Asher. There is a drawing for the electronics in the documentation of the injection machine. I can understand this is still a bit complex. However we haven’t got another picture of it. We are currently developing Version 2 and they will have much better documentation and images. Meanwhile I suggest to search for something like this on google. “connect PID controller with SSR”
Good luck, hope you can make it happen!

Viewing 1 replies (of 1 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪