We've just launched our map. Add yourself by clicking here!


Electronics Tutorial 4 Extruder

  • This topic has 2 replies, 3 voices, and was last updated 3 years ago by Anonymous.
Sam Moss s20r06m

Electronics Tutorial 4 Extruder

06/07/2018 at 01:41

I’m super hyped to make an extruder machine, but I’m not the greatest at the wiring and the schematics have gotten me a little confused.
I have the exact same components that Dave uses in the tutorial, and as I’m a visual learner, can anyone create a step by step video to show what wires go where, or even a few very detailed descriptions and (real life) images, that would be amazing!!! Or even better, could someone direct me to where I could visually see what to do.


2 replies
1 subscribers
0 saved
sort on most likes
06/07/2018 at 11:50

There is a tutorial on the forum… you must check.

06/07/2018 at 13:03

it’s stupid simple at the end: https://www.youtube.com/watch?v=yYyAA6mnTPo. so you’re search on google : ‘pid controller wiring’. what’s not clear in the video is that power supply goes into the pid controller, and forwards only one phase to the relay, the other phase of the relay is going to the same terminal as the power supply.

i would also recommend to install a fuse/breaker, and you should have extra toggle buttons for each headband

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪