We've just launched our map. Add yourself by clicking here!


Extruder torque

This topic contains 1 reply, has 2 voices, and was last updated by  Fabrizio Forte 2 years ago.

Simon Whitehead simonw

Extruder torque

14/07/2018 at 12:47

Hi Dave, I am looking at assembling the bits for the extruder, and was aware from the videos that to produce beams required a higher torque than to produce filament. My question is, if I have a motor that can produce enough torque to produce a beam, can this also be used for filament, or would it produce too much compression? Basically do I need to make another extruder or can one machine be capable of both.
Cheers Simon

1 replies
1 subscribers
0 saved
sort on most likes

In reply to: Extruder torque

15/07/2018 at 19:27

You can use the same motor / Extruder

Viewing 1 replies (of 1 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪