Extruder torque
- This topic has 1 reply, 2 voices, and was last updated 3 years ago by .
Hi Dave, I am looking at assembling the bits for the extruder, and was aware from the videos that to produce beams required a higher torque than to produce filament. My question is, if I have a motor that can produce enough torque to produce a beam, can this also be used for filament, or would it produce too much compression? Basically do I need to make another extruder or can one machine be capable of both.
Cheers Simon
1 replies
1 subscribers
0 saved
0
likes
Viewing 1 replies (of 1 total)
You must be logged in to reply to this topic.