Gas Filtration
- This topic has 1 reply, 2 voices, and was last updated 2 years ago by .
Hi everyone,
We are working on a diy gas filtration system to add to the extruder.
We would like to know, does anyone of you test the air quality of his/her extruder ?
Thank you in advance,
Regards,
1 replies
0 subscribers
0 saved
0
likes
sort on most likes
Some information here http://onearmy.world/community/forums/topic/v4-fume-extraction-4/ . And, kind of hard to find on the new V4 site https://community.preciousplastic.com/academy/plastic/safety . Not sure why PP chooses to not put a safety link on the front page.
Viewing 1 replies (of 1 total)
You must be logged in to reply to this topic.