We've just launched our map. Add yourself by clicking here!

close

Hexagonal Bar

This topic contains 3 replies, has 2 voices, and was last updated by  Daniel Radcliffe 5 years ago.

0
shady novaihed novaqui

Hexagonal Bar

12/07/2016 at 14:54

Hi All.

Can anyone guide me in order to select the right hexagonal bar?

I do not seem to find it anywhere in Australia.

3 replies
0 subscribers
0 saved
likes
sort on most likes

In reply to: Hexagonal Bar

starter
12/07/2016 at 23:14
0

I’m not from Aus, so I cant promise this is correct, But for me, I’ve found a crowbar handle (trimmed off at one end to length) works perfectly. Obviously, Its got to be a hexagonal crowbar, but all mine are, so that wasnt an issue.

In reply to: Hexagonal Bar

starter
13/07/2016 at 17:11
0

Hi @dan3008.

Can you guide to which crowbar size you used or at least give me the link of the product so I can find the similar one in the retailers here?

Thanks man or woman.

In reply to: Hexagonal Bar

starter
15/07/2016 at 23:57
0

I used the largest one my local hardware shop stocked. But then, I was quite happy to adjust the laser files to fit my needs. I ended up with a bar with a 1 inch “diameter”

The best advice I can offer would be to get your hex bar before you send any metal to be cut, that way you can adjust the cuts to suit

Viewing 3 replies - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪