We've just launched our map. Add yourself by clicking here!

close

How to tighten flange bearings on shredder?

Tagged: ,

This topic contains 6 replies, has 3 voices, and was last updated by  Ben 2 months ago.

0
Ben bdurack

How to tighten flange bearings on shredder?

23/07/2019 at 16:22

Hi folks,

Part way through assembling our shredder and all going well so far. I notice in Dave’s video he bolts the flange bearings right at the end which makes total sense in ensuring you have the blades lined up well. I want to be able to do this, but not sure how? How do I access the bolt heads to tighten to nuts and ensure the flange bearings are attached nice a tight? I have lock nuts to ensure the bearings stay tight over time too.

I’m sure I must be missing something simple?? Any help would be greatly appreciated!

Thanks in advance!!

Attachments:
6 replies
1 subscribers
0 saved
likes
sort on date
new
24/07/2019 at 12:43
1

solved: Just used two nuts on the end of each bolt to create an old school lock nut. Used that to then slacken the other nut, allowing me to adjust the bearing position 🙂 Hopefully that might help anyone else stuck in the future

Attachments:
24/07/2019 at 12:18
0

Well, there are versions out there addressing some problems; ours as in the link I’d say is a pre-v4 version.

However, I don’t know how much play you have on the axle & bearings but I do know there is quite errors coming with laser cut for cycle pockets. If you could manage to assemble this on a flat stone plate and use self made gauge blocks (some metal cut offs) to align the axle up in both directions then you can reduce the damage of misalignment at least.

Sorry for the mess; I am adding this to the wiki as well. Please keep us posted, always interesting to see how folks manage this step.
thanks.

new
24/07/2019 at 11:57
0

I thought this was the standard version? It’s the standard files – and trying to follow Dave’s video for the assembly, but he appears to somehow tighten the bearing with everything else assembled and there just doesn’t seem to be the access to hold onto the bolt head to do that. Only option I can see is as you say. I have been assembling, finding where it clashes and marking the outside frame to where I think the bearing should be moved to, to get clean movement.

What version have you assembled out of interest?

Thanks for the help!

24/07/2019 at 11:27
0

Not sure I fully understand and we’ve never used this version but how about this:
1. assemble it all as best you can
2. take a pen and remember the bearing position by drawing an outline along the bearing edges or use superglue
3. disassemble all til the point you can tie up the bolts

this procedure still leaves some axle alignment errors and I am honestly puzzled how to do this too 🙂

possibly somebody from the mechanics department of PP can step in. I think @davehakkens seems to be the new moderator.

new
24/07/2019 at 10:45
0

Thanks for linking to this thread – some interesting suggestions in here but I can’t see anything about how everyone is tightening the bearing?

Are people welding the bolt to the plate so you can simply tighten a nut without having to hold the bolt? I can’t see how if leaving the bearings until the end, you can get access to the bolt heads to tighten the nuts?

new
23/07/2019 at 20:41
0

yes, that’s a tricky one; please create a fixture to simulate the end position and tie them up. I didn’t cover this particular case but here some inspiration.

Viewing 6 replies - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪