We've just launched our map. Add yourself by clicking here!

close

Injection machine doubts

This topic contains 0 replies, has 1 voice, and was last updated by  Ana 3 years ago.

0
Ana velveteen

Injection machine doubts

27/04/2018 at 09:47

Hello!
I have some questions about the injection machine before to build it!
How much force has to be exerted on the lever of the injection machine? Do you think it is possible to make a machine with a nozzle that allows to extrude a bigger section of plastic than the original design? Or would it be to hard to inject the material?
Does anyone build a machine to extrude plastic tube?
Thank you very much!

Ana

0 replies
0 subscribers
0 saved
likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of Lea Fabienne Joswig
    Profile picture of arnaud
    Profile picture of PlasticHub
    Profile picture of Lange
    Profile picture of Robert  Dahm
    Profile picture of Freddy Chang
    Profile picture of Sasha
    Profile picture of Hernan Torres
    Profile picture of yash gohel
    Profile picture of Văn Phòng Phẩm An Lộc Việt
    Profile picture of Maxim Yahia
    Profile picture of arif rahman saleh
    Profile picture of PON MAA KISHAN A
    Profile picture of Akshay Ramesh
    Profile picture of Anik Islam
    Profile picture of Ananyabrata
    Profile picture of Aditya Lavania
    Profile picture of Rocky C
  • Recent Replies

  • Support our projects on Patreon so we can keep developing 💪