We've just launched our map. Add yourself by clicking here!


Injection time cycle and mould process

This topic contains 1 reply, has 2 voices, and was last updated by  Olivier 1 year ago.

Mirko dotcom22

Injection time cycle and mould process

02/02/2018 at 10:08

Hello guys

I wondering if some of you could share their experience with Injector. In the official video here https://youtu.be/ZYFoWP-3MYE about mould injection, we can see at the end they release the iphone mould from the injector and extract the iphone case. In the video we see directly but in practice I suppose is necessary to wait before open the mould…but how much time ?

thank you

1 replies
0 subscribers
0 saved
sort on most likes
04/02/2018 at 05:49

Hello @dotcom22
Cooling time depends on several factors like the plastic type you use, ambient temperature and how much insulation does the mould provide.

For instance, waiting 30min after filling the mould with plastic is normally enough wait time. However, if you put the mould in a bucket with Iced Water, the waiting time could be reduced to about 10min

Viewing 1 replies (of 1 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪