We've just launched our map. Add yourself by clicking here!

close

Motor connection assistance

Tagged: ,

This topic contains 0 replies, has 1 voice, and was last updated by  David 3 months ago.

0
David mangaotaku

Motor connection assistance

13/10/2019 at 18:54

Good afternoon,

I’m currently in the process of trying to finish up my shredder so that I can actually start shredding plastics! I’ve come across a final issue ( I hope ).

Currently I have the shredder assembled, and I also have two keyed motors (7/8 inch shaft) and a Boston gearbox which reduces to about 60-70rpm with a keyed shaft ~1 1/4 inch diameter and a gear with almost 1/2 inch teeth.

Currently the shredder shaft I have is not keyed, and seems to be about 20mm, almost 3/4 inch diameter.

I’m trying to figure out the best way to connect the motor to the shredder, I was thinking of adding a gear on the shaft and using a chain, but I can’t seem to find the correct sprockets and shaft connections required. Or would it be cheaper to key the shaft and use a keyed connection with sprocket?

Any assistance would be greatly appreciated.

Thanks,
David

0 replies
1 subscribers
0 saved
likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of Cleveroad
    Profile picture of Nico
    Profile picture of Nats Kanadzu
    Profile picture of Daniel Eduardo Ragona
    Profile picture of sarah rose
    Profile picture of burak hamza
    Profile picture of Kurniawan adi
    Profile picture of PlasticHub
    Profile picture of Rodrigo
    Profile picture of HairRevitalXReview5
    Profile picture of Pangrango
    Profile picture of Chin-Yuan Yeh
    Profile picture of Sagar
    Profile picture of BloodBalanceFormula23
    Profile picture of Situs Judi Slot Casino Online QQOWL
    Profile picture of Lonnie Dukes
    Profile picture of Alisah Wilson
    Profile picture of SleepWave8
  • Recent Replies

  • Support our projects on Patreon so we can keep developing 💪