We've just launched our map. Add yourself by clicking here!


Need Help building a injection machine :)

Kugi Barraza kugi

Need Help building a injection machine :)

16/04/2020 at 01:48

Im building a injection machine (exactly the same one of the main video), but i can’t find the specifications of the tubes (the one that presses the plastic nor the one you heat). Could you help me?
Can you tell me the diameter of each tube or how mach is the difference in mm from each tube?
Do they both also have to be from steel or you would recommend a different material for each?


2 replies
1 subscribers
0 saved
sort on most likes
16/04/2020 at 04:03

There should be drawings and a bill of materials in the download kit. The important thing is what is available in your area. The inside one (piston) is usually a solid rod, though if you find a way to close off the end and the walls are thick enough so it does not bend, you could make a tube work. The outside tube and the band heaters you can find need to be consistent in size. As the instructions say, check the outside tube to make sure it is smooth (no weld seam). You could use aluminum if you have a good way to attach sturdy mounts.

Good luck

17/04/2020 at 01:12

Thanks for the info! Today I finally found a good steel piston and tube 😉

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪