We've just launched our map. Add yourself by clicking here!

close

Need help with understanding parts

This topic contains 2 replies, has 2 voices, and was last updated by  Gerad Drolet 4 years ago.

0
Gerad Drolet mutt1900

Need help with understanding parts

16/01/2017 at 13:31

thank you for any help.
I am looking at building an plastic extrusion, but not sure of the heat coil or controller, been looking on eBay but not sure if I’m looking at the right parts.
electrical is not my strongest thing, I always get a good charge out of it, so I’m trying to stay away from the hart boost .lol

2 replies
0 subscribers
0 saved
likes
sort on most likes
helper
16/01/2017 at 16:39
0

check for “band heater” and “PID controller”.

helper
17/01/2017 at 04:53
0

Ok thanks,well I looked and I have no idea what I need I’m using a 1″
Barrel inside measurement!
Not sure on volt and watts that is needed. And what controller is best
I’m good in the assemble it just don’t do well in understand electrical, but I know not to lick your Finger on a live wire!
Again thanks for the help

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪