We've just launched our map. Add yourself by clicking here!

close

nozzle-less extruder

This topic contains 0 replies, has 1 voice, and was last updated by  citamrac aurf 2 years ago.

0
citamrac aurf carmatic

nozzle-less extruder

29/09/2017 at 19:37

Hello everybody, I have a question

If the nozzle of the extruder was replaced by an extension of the pipe body which is unheated, will it be feasible to make thick rods instead of filaments?
This assumes that the plastic is not going to adhere to the inner walls of the pipe body as it cools, allowing it to keep sliding out as a solid cylinder

0 replies
0 subscribers
0 saved
likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of Olivier
    Profile picture of KAMEL EL NOUR KHEBIZI
    Profile picture of Paulina Druzynska
    Profile picture of Ertwyn Henry
    Profile picture of caci
    Profile picture of Gilles Crahay
    Profile picture of Lauren Rowell
    Profile picture of Thomas Rebuffel
    Profile picture of jose
    Profile picture of Nick Frank Degenaar
    Profile picture of diego
    Profile picture of Real Recycling
    Profile picture of Hector Londoño
    Profile picture of Glyn Daniel
    Profile picture of tzu
    Profile picture of Kurt
    Profile picture of Michiel van Vliet
    Profile picture of Michaela Bailey
  • Recent Replies

  • Support our projects on Patreon so we can keep developing 💪