We've just launched our map. Add yourself by clicking here!

close

Nylon Zip Ties

Anthony anthonyvanv

Nylon Zip Ties

26/03/2020 at 15:18

I’m sorry if this has been covered already, but its hard to search on the forums and get the results you’re looking for.
So, i have an injection machine i built and it’s working great.
I have a TON of zip tie clippings from my job that i’ve been saving. They fit perfectly in my injection machine. However, i can’t seem to nail down a temperature for this. The zip ties seem to just soften and get jammed up in my nozzle.

I have done failed nylon 3d prints but it seems to melt at 240c on my machine.
What is a good starting point if this can be done?

1 replies
2 subscribers
0 saved
0 likes
sort on most likes

In reply to: Nylon Zip Ties

starter
10/01/2021 at 23:42

I have no experience with this, but have you tried shredding them?

edit: from what I found online, nylon’s melting point is either 218°C or 257°C not sure what the difference is though

Viewing 1 replies (of 1 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪