We've just launched our map. Add yourself by clicking here!

close

Plastica stick To The mold

This topic contains 0 replies, has 1 voice, and was last updated by  yari Battistini 7 months ago.

0
yari Battistini yappo86

Plastica stick To The mold

18/12/2018 at 00:48

Hello, I need an idea not to make the plastic wire stick from the extruded to the mold. thank you all

0 replies
1 subscribers
0 saved
likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of PlasticHub
    Profile picture of Karl
    Profile picture of Stan
    Profile picture of Slava
    Profile picture of Ben
    Profile picture of Simon
    Profile picture of Mark
    Profile picture of Tom
    Profile picture of Kevin Schaper
    Profile picture of Stuart Rixon
    Profile picture of Carla-Lisa Dikdur
    Profile picture of Adam Beaney
    Profile picture of Максим
    Profile picture of Robin Schapiro
    Profile picture of Adam Comfort
    Profile picture of Robbie
    Profile picture of Russell Detar
    Profile picture of vee
  • Recent Replies