Recycling bottle caps
Hi I am new here and already finding the site a mine of information:-)
Sometime in the past our company started collecting bottle caps and unfortunately did not separate them into different types so we now have 4 bulk bags ( approx 3 tonnes) of mixed PP and HDPE tops.
Any suggestions/ideas of what we could do with them?
We also have about 1 tonne (and growing) of granulated PET/PP mix.
Thanks to @alexsav
“If you have large batches and motivation, you could think of a sink/float method with a liquid medium that has a density between those of PP and HDPE. There is also research for separation of PP and HDPE size particles with hydrocyclones they are quite low cost but require a lot a fine tuning to get good efficiency.”
Study on the light medium separation of waste plastics with hydrocyclones (PM me for the full article)
Hi – Thanks for that.
I was hoping to be able to somehow separate the PET/PP granulated mix by dumping it in a water tank and then skimming the floating PP off the surface?
Hey there @ianrobbo !
bottle caps will “always” be PP or PE (which are from same family Polyolefin).
in order to have best quality of product output, i would recommend only using “food-grade” bottle caps, as the types of additives in them should be limited.
concerning the granulated PET/PP mix, from my point of view you won’t be able to do anything with it; PET & PP have highly different chemical stucture and product output will be very brittle (and not rerecyclable)
hope the info helps you out x)
You must be logged in to reply to this topic.