We've just launched our map. Add yourself by clicking here!

close

Shredder Gear Box Thingy

This topic contains 2 replies, has 2 voices, and was last updated by  Fool 3 years ago.

1
Fool paulfreed

Shredder Gear Box Thingy

06/04/2016 at 16:45

Hi Guys,
The gear that you’ve used on the shredder motor (the 90 degree thing between motor and shredder shaft) – what is it exactly? Does it have a specific ratio or speed reduction?

Do you think id run into problems with torque if i mounted my motor shaft directly to the shredder shaft? I’m confident that l’ll be able to achieve the speed i need, but im just not sure if im gonna go into some kind of over current straight away at normal load. Have you guys tried this?

Cheers,
Paul

2 replies
1 subscribers
0 saved
1 likes
sort on most likes
warrior
06/04/2016 at 18:12
0

Hi paul

The shredder requires quite some torque, we used a motor with a worm wheel to get the job done. However you could also use other ways to accomplish this, belts, gears etc. In the end it doesn’t really matter that much how fast it goes but you do need torque.

*also moved topic in the right section

helper
08/04/2016 at 11:20
0

Ahh, thanks for moving it.

Do any of you guys know the worst case torque in N.m would be? I presume with say two bottle lids at the same time?

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪