We've just launched our map. Add yourself by clicking here!


shredder not turing free

This topic contains 2 replies, has 3 voices, and was last updated by  Jerry de Vos 2 years ago.

plekke plekke

shredder not turing free

01/09/2017 at 22:50

if i mount the shredder case with M10 nuts
then the axle with knives on the side , has to much friction with the sides

is this so in the design ?

can i tweak this ?

View post on imgur.com

2 replies
0 subscribers
0 saved
sort on most likes
02/09/2017 at 00:40

Hey @plekke !
I had that problem too. Took me an hour or so of readjusting but eventually it ran perfectly smooth. So I’d say: unscrew, adjust, tighten the screws and repeat. :/
Hope that helps…

03/09/2017 at 13:52

Indeed try readjusting

if you really really really cant manage, put a piece of an aluminum drinking can between the last plates on the side (see yellow line picture)

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪