We've just launched our map. Add yourself by clicking here!

close

Shredder's SIEVE specifications

This topic contains 5 replies, has 5 voices, and was last updated by  KAMEL EL NOUR KHEBIZI 1 week ago.

0
Javier (Singular MARS) javierrivera

Shredder's SIEVE specifications

12/07/2017 at 19:35

Hey all,

to those who have built the shredder, I have a question: What kind of perforated sheet have you used? Which one works best? You can buy all kinds with bigger or smaller holes, and it doesn’t say what to use, which one works best for you?

For v3 it would be interesting to make the sieve more easy to replace: not having it welded to the sieve plates, so that if you want to change for one with bigger holes you don’t need to weld plates again.

Ciao

5 replies
2 subscribers
0 saved
likes
sort on most likes
new
02/12/2019 at 08:59
1

Hey,
what is the specification of sieving screen??

hero
03/12/2019 at 19:00
2

It depends on how small you want your shredder plastic, I wouldn’t chose anything less than 6mm diameter to avoid clogging

dedicated
04/12/2019 at 14:23
1

It’s not only about the diameter of the holes but also about space between holes, this is often defined as % of “air”. My seive has 8mm holes but rather big spaces between holes. Which introduces accumulation of flakes on one side of the shredder.

new
05/12/2019 at 08:35
1

Hey,thanks. Btw is shredder and agglomerator both required? And why is water add in the agglomerator? Wouldn’t  the moisture affect the further process?

starter
05/12/2019 at 17:12
3

in my country people prefere the 8 mm diameter

Viewing 5 replies - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪