We've just launched our map. Add yourself by clicking here!

close

Testing extrusion nozzle

This topic contains 2 replies, has 1 voice, and was last updated by  Pim van Baarsen 4 years ago.

1
Pim van Baarsen pimvb

Testing extrusion nozzle

19/01/2016 at 15:18

After extrude a lot of round material it was time for a new challenge…

So I decided to to start testing with a nozzle for flat extrusion.
Luckily enough I found this clutch piece that fits the machine (hurray universal piping system!).

Made a very first test nozzle. Now waiting for the machine to warm up!

Attachments:
2 replies
0 subscribers
0 saved
1 likes
sort on most likes
helper
19/01/2016 at 16:53
0

Although the result is a bit irregular, the new nozzle definitely gives a different extrusion.

Now I need a way to prevent it from turning and find a proper way to get it on a reel.

Attachments:
helper
19/01/2016 at 17:15
0

Flat extrusion

Attachments:
Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪