We've just launched our map. Add yourself by clicking here!

close

URGENT HELP NEEDED: Changing shredding axe diamete

This topic contains 4 replies, has 3 voices, and was last updated by  Jonathon Stuckings 3 years ago.

1
Daniel denyo1986

URGENT HELP NEEDED: Changing shredding axe diamete

24/04/2017 at 09:55

Hello everyone,

I need some help of experienced shredder builder around the world 🙂

My potential steel supplier told me he can only get the steel bar in 28mm diameter.
I understand that this change requires the hole in the shredding knifes to be adjusted to 28mm diameter, too.

Are there any other impacts?
Any other parts that need to be changed?
Will this change cause any problems e.g. due to not enough space in the box or something?

Any advice is appreciated.
Thank you for your help.

Cheers,
Daniel

4 replies
0 subscribers
0 saved
1 likes
sort on most likes
starter
24/04/2017 at 09:58
0

I should have mentioned that the change is from 27mm to 28mm…

helper
24/04/2017 at 14:48
0

It should only be the rotating knifes and spacer that need to be adjusted.

starter
28/04/2017 at 13:20
0

Thank you very much @ashrak

Any other opinions out there?

starter
10/05/2017 at 12:31
0

Do It!

I have done it in australia up to 28.25mm A/F and the hex bar is 1/10th of a mm less.

make sure the hole stays centred on the drawing and have fun.

While you are playing around the aspect ratio is wrong on it. have a look.

Viewing 4 replies - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪