We've just launched our map. Add yourself by clicking here!

close

Use only one thickness (shredder)

This topic contains 0 replies, has 1 voice, and was last updated by  Adrien Luitot 3 years ago.

0
Adrien Luitot adrienluitot

Use only one thickness (shredder)

19/07/2018 at 12:24

Hello,

Is it possible to use only 5mm for the laser cut parts ? Instead of using 3mm, 5mm and 6mm.
I know that I’ll have to adjust all the plan but I think that could be less expensive isn’t it ?

0 replies
1 subscribers
0 saved
likes

You must be logged in to reply to this topic.

  • Folks that were just here

    Profile picture of danilo nereu nunes
    Profile picture of Victoria Petrovic
    Profile picture of Abdelelah Qutub
    Profile picture of Pablo
    Profile picture of andrea tamburrini
    Profile picture of Katee Hargraves
    Profile picture of Abdul K
    Profile picture of Marcelo Vicente
    Profile picture of Sasha
    Profile picture of Ramdhan
    Profile picture of Cristina
    Profile picture of Benneth
    Profile picture of Kamil Rynczak
    Profile picture of nachwan
    Profile picture of Garrett Cadou
    Profile picture of Georgi
    Profile picture of Benlly
    Profile picture of PlasticHub
  • Recent Replies

  • Support our projects on Patreon so we can keep developing 💪