We've just launched our map. Add yourself by clicking here!

close

Using a belt system for stepping down the motor

  • This topic has 2 replies, 3 voices, and was last updated 2 years ago by Anonymous.
Ursula Mann tavyscrapstore

Using a belt system for stepping down the motor

09/03/2019 at 17:44

Hi,
We’re just beginning the process of making our shredder.  Wanted to check out some design changes to see if anyone else has made similar:

1. Use a belt system in stepping down the motor to increase safety and ensure that blockages don’t ruin the gearbox or motor.

2. Remove the external portion of the shaft that sticks out from the end of the cutter box as it’s not necessary and as it turns presents additional risk.

3. Add a safety break to the hopper so if it’s lifted the motor is turned off.

Anyone have experience with the above?

2 replies
1 subscribers
0 saved
0 likes
sort on most likes
warrior
10/03/2019 at 15:06

@tavyscrapstore

1. The problem with belts is they will slip at the sort of torque required here, even toothed belts are best at providing power through higher speed rather than low speed/high torque. You’d be better off using chains and sprockets, you will probably need at least a 2-stage reduction if using chain/belts, you may be able to get away with belt drive for the first stage.

2. Yes, this bit that sticks out is not much use unless you’re going to do something with it. Most people don’t

3. An interlock on a lid on the hopper is a very good safety feature and easy to implement in a number of ways (I did this on mine). The problem is with the single-shaft design plastic often needs pushing into the rotating blades to get it to start to shred, making an automatic pusher to do this with the lid closed is possible but a lot more complicated.

…
10/03/2019 at 20:48

1. you could try using multiple belts as it’s done in a lathe, in the first stage this would be alright as andyn says. however, such thing would require precise aligned pulleys and an adjustable tensioner. if you have a lathe and good equipment, that could last the whole day; getting a reducer might be cheaper and more effective at the end.
2. if the motor is strong enough you may add something later as andyn says. adding an extruder for instance, or a shredder which is for small size flakes could eliminate the need for another motor/vfd and reducer.

Viewing 2 replies - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Support our projects on Patreon so we can keep developing 💪