Using the same parts for extrusion and injection
- This topic has 0 replies, 1 voice, and was last updated 3 years ago by .
Hi everyone, It occurred to me that the parts for the extrusion barrel and electronics are identical to the injection barrel and electronics, so why can I not use the same parts for both? It seems easy enough to move the barrel from one location to another. Especially if I lengthen the cables and have the machines next to each other.
I don’t imagine wanting to run both machines at the same time, and it will save me expense and complication getting the parts again.(my location is very remote).
Any obvious reasons not to do this?
Thanks,
Matt.
0 replies
1 subscribers
0 saved
0
likes
You must be logged in to reply to this topic.