Forum Replies Created

Viewing 4 replies - 1 through 4 (of 4 total)
sort on most likes

In reply to: mold quick release

starter
10/03/2020 at 04:18
0

I like this idea! I might do this on my injection machine! Thanks!

starter
10/03/2020 at 04:13
0

Thank you guys for the tips! Turns out I was just not waiting long enough for the plastic to heat up. Sorry. I’m new.

starter
08/03/2020 at 14:17
0

Aren’t they supposed to be attached to the heaters? Do you think a temperature laser would work?

starter
05/03/2020 at 15:30
0

I’ve done it. I used my anycubic photon resin printer with a high temperature resin for the mould. They were very small parts about the size of a large coin. I haven’t used it long term but it worked very well when I did use it. I didn’t have mould release so I used a cooking spray on the mould. The resin is rated for 200 degrees C. I was injecting PETG at 290 degrees with no issue. Like I said, long term, this probably isn’t ideal but good for a few quick tests before getting a proper mould.

Viewing 4 replies - 1 through 4 (of 4 total)