Halim Widya Kusuma
Forum Replies Created
i think it doesn’t really affect on motor that much, because the concept of transmission is the same power. single or double screw will be the same torque to crush the plastic. double shaft is designed for faster shredding because the blade will reach the cutting point easier, motor stay still.
below formula of shredding unit power (P1) & motor unit (P2)
man power shredder? @charmaineyeap, here’re some posts might help 🙂
2. alternative shredder
but, there are more alternatives i’ve collected from forums like …
1. shredder blade
2. alternative shredder
i’ve read your post, something about looking a way to make this machine cheaper to be built, i’m still new here but very happy knowing that so many people interested in recycling 😀
i agree that cost can be annoying problem, but i suggest to not forget about effectiveness. I would recommend join group order. in my country, join group order can lower shredder kit cost up to more than 50%. you can see in here..
btw, it has a savoury looks 😀
very usefull stuff u got there, very happy to see other functional application of recycled plastic 😀
keep up the great work!!
it’s a tricky idea 🙂
i would like to watch the shredding process..
hi from tulungagung – east java
hope these topics will help:
(i add some “non-bike” but still human power, might got some inspiration on mechanical system)
regards, halim 🙂
have you visited “metric-inches” topics?
i haven’t found it yet, but hope this will help 🙂 (just mould topics)
@wolvincraft, here some discution about wood chipper might help
hello @martink, it can be an option, the same fact in my country, cheaper :).. but to be note that less customization you’ll get.
again, (in my country) the prize is not too far between..
my suggestion: find group order from the same precious plastic guy in your country. in my country i can get 80% cost down by shredder kit group order.
any feed back are welcome 🙂
the same as you, i’m interested in gas based oven. unfortunately, i don’t have enough knowledge about controller – arduino based (olivier suggested in instructable.com).
do you use olivier suggestion, or there is another simple system controller? maybe mechanical controller?
best wishes, halim 🙂
here’s some topics might help
beautifull shape & colour blend 🙂
could you share your mold photos please?
these guy also melting without compressing,
is it work fine?