Landry Le recycleur fou

@anthonyp je suis ton homme, contact moi par message privée.

Yes, it will be in the next download kit

and …

Other screenshot

Hey community

@rbagg066, yes it will be the next download kit.

We work on it, like you can see 🙂

For assembly it, with all the part, take around 2 hours without the frame and hopper.
We will start the test the 29 July.

So, what we need:

It needs higher torque: it get stuck with cd cases and big HDPE bottles. We want to keep the same power (around 3kW). That means we have to lower the speed to get higher torque. So we need a higher ratio for the gearbox. New blades: Flakes are too big. More teeth and less thickness Hard to clean: The flakes can accumulate in…[Read more]

Hey community :

For this shredder we have a 3 phases motor with these specs:

Power: 3kW

Output speed: 65rpm

Nominal torque: 440 Nm

Gearbox Ratio: 1:21,43

After building the first V4 shredder, we have test it during 2 weeks with differents plastics :

PP : Sheets, DVD cases, buckets…

HDPE : Sheets, Bottles, Buckets

PS : Sheets

we have d…[Read more]

Good, it looks very interseting!
The differents tests does with the doubles axes make the plastics chips to thicks. That because the blades are not crossing enought, like the Fig 1 on the picture. We need to cross more, with larger diameter blades and smaller diameter washer, change the the space between the 2 shafts like the Fig 2 AND change the…[Read more]

Hey community,

We have start the test of the double axis shredder, we will try different sheet with different thicknesses and compare the result with the single shaft.

We have decided to try with cutting blades to test the capacity of the shredder to grip the sheet.

Then, we will check if the flakes are enought small for be injected or…[Read more]