Forum Replies Created

Viewing 4 replies - 1 through 4 (of 4 total)
sort on most likes
starter
08/03/2019 at 20:33
2

Hi, I also encountered the problem of fitting pipes for an injector! My solution to this problem: I welded another pipe cut in half and tightly pressed to the main pipe. Based on the dimensions of the heaters, we cut the necessary length and weld it at the location of the heaters, as a result we get not 33.4 mm, but 35 mm. This is for the injector, and for the extruder there will be a problem with the selection of the auger! I did the injector under 25 mm. I apologize for the English language, I use the translator.

Attachments:
starter
08/03/2019 at 19:54
1

Hi, thanks for the useful information!

In reply to: Ask Me Anything

starter
25/02/2019 at 23:11
2

Hi Dave, that’s what happened, thank you! I will show on YouTube, Pavel K.

Attachments:

In reply to: Ask Me Anything

starter
25/02/2019 at 22:49
2

Go to the bazaar site or make your own according to the drawings!

Viewing 4 replies - 1 through 4 (of 4 total)